Tripp Lite SR4POST - Manual

Contents
1 -Base
(2 Pcs.)
1 -Base
(2 Pcs.)
2 -Post
(4 Pcs.)
2 -Post
(4 Pcs.)
3 -Side lower members
(4 Pcs.)
3 -Side lower members
(4 Pcs.)
4 -Center lower members
(2 Pcs.)
4 -Center lower members
(2 Pcs.)
5 -Side upper members
(4 Pcs.)
5 -Side upper members
(4 Pcs.)
6 -Center upper members
(2 Pcs.)
6 -Center upper members
(2 Pcs.)
7- Top support bracket
(2 Pcs.)
7- Top support bracket
(2 Pcs.)
3/8¨-16 UNF hex nut
(32 Pcs.)
3/8¨-16 UNF hex nut
(32 Pcs.)
3/8¨X 7/8¨ Spring washer
(32 Pcs.)
3/8¨X 7/8¨ Spring washer
(32 Pcs.)
* Equipment Hardware
12-24 X 5/8”Cilindrycal head screw (56 Pcs.)
PVC black flat washer (56 Pcs.)
12-24X5/8” Conical screw washer (56 Pcs.)
PVC White flat washer (56 Pcs.)
Cable manager hooks...
(32 Pcs w/mounting fasteners)
12-24 x 5/8 Screw (56 Pcs.)
1 1
Assemble Base & Posts
* Place base on a hard flat surface. Use 3/8¨
Screws to attach base to each post
2 2
Assemble top support bracket
* Verify alignment
3 3
Pre-Assemble upper and lower
side memebers
* Set desired depth
Use 3/8¨Screws and tighten members
4 4
5 5
6 6
Install Cable Manager Hooks as desired
* Use included plastic fasteners
3/8¨-16x1¨UNF screw
(32 Pcs.)
3/8¨-16x1¨UNF screw
(32 Pcs.)
Required Tools
Assembly hardware
9/16¨ Wrench 9/16¨ Wrench 9/16¨ Socket, Ratchet 9/16¨ Socket, Ratchet
MODEL: SR4POST
ADJUSTABLE OPEN RACK
24
24
Assembly Instructions
1 1
2 2
3 3
4 4
7 7
5 5
6 6
Install Pre-Assembled upper
side members as shown
*Use included nuts .Fasten tightly
Install Pre-Assembled lower side
members as shown
* Verify alignment before tightening
2A. repeat for rear side
1A. repeat for rear side
1111 W. 35th St, Chicago, IL 60609
(773) 869-1234 www.tripplite.com