Tri-M Systems REB 2000 - Manual (Page 6)

Tri-M Systems Inc., 6-1301 Ketch Court, Coquitlam, B.C. V3K 6X7, Canada
Phone: (604) 527-1100, (800) 665-5600 Fax: (604) 527-1110
Email: [email protected] Web: www.tri-m.com
5
12. How to update software of REB-12R series GPS engine board?
Ans:
1. Turn off the power.
2. Keep
the Select pin high.
3. Turn on the power.
4. Run the SiRFProg.exe.
5. Select the Target Loader File. Select dltarget.s for REB-12R series.
6. Select the Target file that need to be programmed into flash memory. For example: Royaltek.s
7. Select the COM port. Keep the Baud rate at 9600 for REB-12R series.
8. Leave “Valid Current Target S/W (SiRF Protocol), Update Boot S/W, GPS2, Load Target Only” check
box unasserted for Reb-12R series.
9. Click Upload to begin programming flash memory.
10. After finish uploading, turn off the power. Keep the Select pin open and turn on power. It will run the
new program uploaded into flash memory.
13. How to update software of REB-2000 series?
Ans:
1. Turn off the power.
2. Keep
the Boot pin high.
3. Turn on the power.
4. Run the SiRFProg.exe.
5. Select the Target Loader File. Select dlgsp2.bin for REB-2100.
6. Select the Target file that need to be programmed into flash memory. For example: Royaltek.s
7. Select the COM port. Keep the Baud rate at 19200 for REB-2000 series.
8. Please assert the GPS2 check box.
9. Click Upload to begin programming flash memory.
10. After finish uploading, turn off the power. Keep the Boot pin open and turn on power. It will run the
new program uploaded into flash memory.
14. How to update software of Sapphire?
Ans:
1. Run SiRFDemo.exe.
2. Select “Action/Synchronize protocol and Baud rate” from menu. Wait for SiRFDemo.exe receives
messages.
3. Select “Poll/Clock status” from menu. Sapphire will stop output messages and wait for new program.
4. Close
SiRFDemo.exe
5. Run SiRFProg.exe
6. Select the Target Loader File. Select dlgsp2.bin for REB-2100.
7. Select the Target file that need to be programmed into flash memory. For example: Royaltek.s
8. Select the correct COM port. Keep the Baud rate at 19200 for REB-2000 series.
9. Please assert the GPS2 check box.
10. Click “Upload” to begin programming flash memory.
11. After finish uploading, turn off the power. It will run the new program uploaded into flash memory.