The First Years VIA I440 User Manual
Page 20
Section 7 - Installation and Use
1
2 -
Remove
BOTH
LATCH Lower
Anchor connectorc from the LATCH
Lower Anchor storage compartment.
3-
Attach the right and left LATCH
Lower Anchor to the anchor points.
Press down on the base with your
knee and pull up on the webbing loop
until the webbing is taut.
4-
CHECK level indicator to ensure the
ball is in the green area.
Pull out on
the yellow release knob and slide
the anglefoot to raise the base or
to lower the base angle
.
CHECK base for movement at
the belt path. Base should not move
more than 1 inch in any direction.
5
-
.
Consult your automobile’s owners
manual or manufacturer for location
and availability of LATCH lower
anchor points.
CRS Connector LATCH Anchor
Points- 7.3
If base moves, repeat steps until
all safety steps are met.
19