Sony KDL-52X2000 - Manual (Page 49)

49 GB
A
d
d
iti
on
a
l I
n
fo
rm
a
tio
n
Sound
Problem Cause/Remedy
No sound, but good picture • Press 2 +/– or % (Mute).
• Check that “Speaker” is set to “On” in the “Set-up” menu (page 32).
Noisy sound • See “Picture noise” causes/remedies on page 48.
Channels
Problem Cause/Remedy
The desired channel cannot be
selected • Switch between digital and analogue mode and select the desired digital/
analogue channel.
Some channels are blank • Scrambled/Subscription only channel. Subscribe to the Pay Per View
service.
• Channel is used only for data (no picture or sound).
• Contact the broadcaster for transmission details.
Digital channels are not
displayed • Contact a local installer to find out if digital transmissions are provided in
your area.
• Upgrade to a higher gain aerial.
General
Problem Cause/Remedy
The TV turns off automatically
(the TV enters standby mode) • Check if the “Sleep Timer” is activated, or confirm the “Duration” setting of
“On Timer” (page 31).
• If no signal is received and no operation is performed in the TV mode for
10 minutes, the TV automatically switches to standby mode.
The TV turns on automatically • Check if the “On Timer” is activated (page 31).
Some input sources cannot be
selected • Select “AV Preset” in the “AV Set-up” menu and cancel “Skip” of the input
source (page 33).
The remote does not function • Check that the remote is set correctly for the equipment you are using.
• Check whether the equipment you want to use corresponds to the function
button being pressed (page 14).
• If the remote does not operate the equipment even when the remote has been
set correctly to the equipment, enter the necessary code as explained in
“Programming the remote” (page 44).
• Replace the batteries.