T-Mobile 535 - Manual (Page 19)

Using of PIN-lock with PCMCIA Option Globetrotter card
For using T-Mobile Communication Centre with PCMCIA card Option
Globetrotter it is necessary to switch off PIN-lock on the SIM-card.
If it is necessary to have it switched on anyway you must install the
original WCM driver available on original Option CD (part of Option
pack). Follow the next steps:
1. Make sure that the card is NOT inserted in the computer.
2. In the case that you have installed the card via T-Mobile
Communication Centre already remove it according to steps
described in chapter 7, Uninstalling the device.
3. When the card is removed in T-Mobile Communication Centre
insert the original Option CD into the device (it should be
automatically started or start it by clicking the GTinst.exe file).
4. Make the WCM installation according to displayed instructions.
Don’t insert the card until you are not asked for that by the installer.
It is possible to interrupt the installation in the time when the
following window is displayed:
5. In the displayed window press Cancel (and also in the next error
message). If you continue in the installation the special Option
manager will be installed – but you don’t need it if you connect via
T-Mobile Communication Centre. We recommend to install Option
manager only if you are going to use e.g. voice functions of the
card).
6. Add the card as a new device in T-Mobile Communication Centre
again.
7. Now you will be asked for PIN input during the connection if the
PIN-lock is switched on in the SIM-card:
Due to problems of the original driver with some configurations of
Windows operating system we don’t recommend its installation and
rather we recommend to switch off the PIN lock in the SIM-card.
In case of using the original driver we recommend to wait 20–30
seconds after the insertion of the card for its full initialization and
then to make connection.
External configuration file for installation
In case of adding the new connection (APN) according to chapter 8
in the directory where T-Mobile Communication Centre is installed is
newly available userconn.ini file. There are parameters of connection
configuration of both standard APN Internet and newly created APNs.
It is possible to use this file if you are going to install T-Mobile
Communication Centre on other computers with the same
configuration of connections. If this file is available in the same
directory as the installation setup.exe file during the installation
T-Mobile Communication Centre will be pre-configured with these
options after the installation. If the configuration file is not available
in the same directory during the installation only standard APN
Internet connection will be configured.
It is possible to edit the file manually too. This is its structure
(example of standard configuration for APN Internet):
[APN Internet]
userName=”gprs“
password=”gprs“
domain=” “
apn=”internet.t-mobile.cz“
ip=0.0.0.0
primaryDns=62.141.0.1
secondaryDns=213.162.65.1
primaryWins=0.0.0.0
secondaryWins=0.0.0.0
proxy=” “
proxyBypass=” “
This group of lines can be repeated in the file as many times as many
different connections you want to create.
19
12. For Advanced Users