TP-Link External ADSL ROUTER TD-8810B - Manual (Page 9)

TD-8810 External ADSL Router User Guide
4
Chapter 2. Hardware Installation
The TD-8810/TD-8810B maintains three separate interfaces, one Ethernet, one ADSL and one
power adapter inerface.
The Router should not be located where it will be exposed to moisture or excessive heat.
Place the Router in a location where it can be safely connected to the various devices as well as
to a power source.
2.1 System requirement
Confirm your computer has been installed with networking interface card (NIC) before connecting
ADSL ROUTER to your computer, with operating system supporting the TCP/IP protocol.
2.1.1 LED explanation
The front panel of ADSL ROUTER includes one power indicator (RED) and seven function
indicators (GREEN), as explained in chart below:
Indicator Description Status Function Details
On Power OK
PWR Power
Off Power fail
Slow flash Self-detecting when power up
Quick flash Connecting to the telecom network
ADSL ADSL status
On Connection to telecom network OK
On
There is mistake when ADSL transmitting data
or receiving data
ALARM Mistake
Off ADSL normal
On
There is data transmitting or receiving on WAN
port
ACT Data
Off No data transmitting or receiving on WAN port
On LAN port normal
Off Connection on LAN port abnormal
LAN Ethernet
Flash Data transmitting or receiving on LAN port
2.2 Rear-panel
¾
ON/OFF: Turn on/off the ADSL ROUTER’s power.
¾
Power (9VAC/0.8A input): Please do not use any unknown power adaptor, otherwise your
ADSL ROUTER may be damaged.
¾
RESET(reset default): First press the reset button of ROUTER, then turn on the ROUTER’s