Thermos 4611118 - Manual (Page 11)

11
Assembly (Con’t.)
- Before assembly, inspect Regulator (J) for damage, dirt or debris
accumulation. Clean out if present.
- With knob pointing down, insert Regulator/Valve (J) into end of
Burner (F).
Notch in Regulator/Valve (J) MUST engage dimple in end of
Burner (F).
- Once Regulator/Valve (J) has completely engaged Burner (F), turn
Regulator/Valve (J) clockwise to lock in position with knob pointing
up.
5
- Remove cap from end of Propane cylinder (sold separately). Cap
should be kept on cylinder when not in use to prevent dirt and debris
from entering Regulator/Valve (J). Check end of cylinder attachment
for dirt and debris. Clean out if necessary.
- Insert threaded end of Propane Cylinder into Regulator/Valve (J) and
hand-tighten. DO NOT USE TOOLS! Over tightening can damage
threads on Regulator/Valve (J).
- Perform a leak test.
6
(not included)
Regulator/Valve (J)
Rotate clockwise to lock
Locked in position
Regulator/Valve (J)
Propane Cylinder