TOA Electronics I6 AW - Manual (Page 3)

1. Introduction
Designed for a wide variety of sound reinforcement applications the Tannoy i6 AW (All
Weather) is an ultra compact loudspeaker system capable of delivering high sound
pressure levels with extremely low distortion, resulting in outstanding clarity, definition
and detail. A truly universal solution, the i6 AW offers outstanding durability and
resistance to scuffs and knocks. Able to deliver consistent performance under a wide
range of adverse conditions the i6 AW is suited to applications indoors or out, whether
it be a theme bar or theme park. Available in dark grey or white the i6 AW will
effectively blend into most backgrounds.
Utilisation of the point source Dual Concentric loudspeaker allows the i6 AW to be
mounted on a wall or ceiling in either horizontal or vertical orientations without
affecting its performance. A range of hardware options ensures simple and effective
installation. Also available with built in line transformer (i6T AW).
The i6 AW comprises one 6.5 inch (165mm) Dual Concentric driver in which the low
frequency (LF) and high frequency (HF) sources are coincidentally aligned to a point
source, resulting in a smooth uniform frequency response over a wide area of
coverage. The sophisticated CAD designed waveguide combines 90 degree conical
dispersion and excellent acoustic impedance characteristics.
For applications requiring extended low frequency enhancement, a range of Tannoy
sub-bass systems are available and can be used in conjunction with the i6 AW.
2. Unpacking
Every Tannoy i6 AW product is carefully inspected before packing. After unpacking
your loudspeakers, please inspect for any exterior physical damage, and save the
carton and any relevant packaging materials in case the loudspeaker again requires
packing and shipping. In the event that damage has been sustained in transit notify
your dealer immediately.
3. Connectors/Cabling
The i6AW has two 4mm binding posts for connection to the amplifier, these are gold
plated in order to improve electrical conductivity and to prevent oxidisation. These
terminals are capable of accepting cables with a conductor diameter of up to 6mm.
Red is Positive
Black is Negative
Cable choice consists mainly of selecting the correct cross sectional area in relation to
the cable length and the load impedance. A small cross sectional area would increase
the cables series resistance, inducing power loss and response variations (damping
factor).
Connectors should be wired with a minimum of 2.5 sq. mm (12 gauge) cable. This will
be perfectly satisfactory under normal conditions. In the case of very long cable runs
the wire size should exceed this, refer to the following table for guidance:-