Toastmaster TK17B - Manual (Page 6)

4. 5.
Before Using for the First Time
Boil a Kettle of water following the Operating Instructions below.
Discard the water.
Operating Instructions
CAUTION: Do not immerse Power Base, power cord, or plug in
water or any other liquid.
1. Position the Power Base on a stable, level surface near an
electrical outlet. Unwind the power cord from the cord storage
Area located beneath the Power Base. Make sure the cord exits
through the cord exit slot on the side of the Power Base.
2. Check that the ON/OFF Switch is in the OFF (up) position.
3. Remove the Kettle from the Power Base. Using the Lid Tab, open
the Lid to its fully open position. Fill with fresh, cold water to the
desired level (see markings on Water Level Window). The Kettle
yields up to 1.7 Liters of water. Use at least 2 cups of water, but
do not fill above the MAX water level. Wipe excess water off
the Kettle.
CAUTION: Do not fill above the MAX water level. This could cause
boiling water to splatter out.
NOTE: If the Kettle is accidentally switched ON without sufficient
water, a boil-dry protection device will automatically turn the unit
OFF. (See boil-dry protection explanation.)
4. Make sure the Filter is in place before use. Boiling water may
splatter without the Filter in place.
5. Close the Lid and press down gently until it snaps into position to
ensure it is fully closed. Otherwise the Kettle may not turn OFF
after boiling.
CAUTION: To avoid the risk of splashing while pouring hot water,
make sure the Lid is securely closed onto the Kettle before operation.
6. Place the Kettle on the Power Base, taking care not to spill
any water.
Lumens® Cordless Electric Kettle Use and Care Guide
Getting To Know Your Lumens ®
1.7L Cordless Electric Kettle
PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS
Power Base
(P/N 31225)
Electrical
Connector
Kettle
Body
Lighted
Water Level
Window
Lid Lid Tab
Filter
(P/N 31224)
Spout
ON/OFF
Switch
Power
ON
Light
Handle
Polarized Plug
Cord
Exit
Top tabs
face inside
Kettle