Turbosound TQ-440 - Manual (Page 8)

user manual
QLight    series
TQ-440 manual
page 8
Mounting and Fixing
A versatile range of mounting hardware is available for the TQ-440 that allows it to be used in a
variety of ways, in either mobile applications or permanent installations.
A top hat stand type fitting A top hat stand type fitting A top hat stand type fitting A top hat stand type fitting is mounted in the base of the cabinet
for use with 35mm diameter loudspeaker stands with a load rating
of at least 37kgs (82lbs).
This top hat fitting may also be used to mount the TQ-440 cabinet
at the correct height above the complementary TQ-425 subwoofer
using a straight 35mm pole.
Internal metric threaded rigging points Internal metric threaded rigging points Internal metric threaded rigging points Internal metric threaded rigging points are provided
in several locations on the cabinet – on the top, bottom
and sides - enabling it to be flown using standard M10
shoulder eyebolts (available from Turbosound).
Downward inclination of the enclosure can be adjusted
using an additional rigging point on the rear of the
cabinet.
Side Side Side Side----mounted flying strips mounted flying strips mounted flying strips mounted flying strips can be fitted to the sides of
the enclosure by removing the countersunk bolts on
the top and sides of the cabinet and replacing them
with the M10 bolts provided with the hardware. Two
FF-440 flying strips are required for each enclosure.
This method offers a simple and cost effective method
of flying single or multiple TQ-440 enclosures, with the
load being taken through the steel strips rather than
through the woodwork of the enclosure. Enclosures
may be arranged in a vertical column by coupling the
flying strips together using QL-75 quicklinks or
shackles.