Top Innovations SF-407 - Manual (Page 8)

A
SSEMBLING THE
F
ABRIC
S
TEAMER
8 Top Innovations, Inc.
ATTACHING THE TELESCOPIC POLE
1. Loosen Pole Base by turning it in a counter-clockwise direction.
2. Insert bottom section of Telescopic Pole into Pole Base (FIGURE 4).
3. Tighten Pole Base by turning it in a clockwise direction until it is tight, and
Telescopic Pole sits firmly in place (FIGURE 5).
FIGURE 4 FIGURE 5
ATTACHING THE FABRIC BRUSH
1. Make sure Lighted On/Off Switch is set to “Off”
position, and that the unit is not emitting any steam. Do
not try to connect Fabric Brush while unit is emitting
steam, as this can cause burns and injury.
2. Align the four pegs on back of Fabric Brush (2 circular
and 2 elongated) with corresponding holes on face of
Steam Nozzle.
3. Press Fabric Brush firmly onto Steam Nozzle, until it fits
snugly and firmly in place (FIGURE 6).
FIGURE 6