Toshiba MK1234 User Manual
Page 3
2.5” Hard Disk Drive Installation Notes -
P/N 480070-B0
P/N 480070-B0
2.5” Hard Disk Drive Installation Notes -
MK1234/1034/8034/6034/4034GSX
05/06
05/06
MK1234/1034/8034/6034/4034GSX
Logical Drive
MK6034GSX
MK4034GSX
Parameters
HDD2D35
HDD2D39
# of Cylinders (user)
79,056
60,912
Bytes per Sector
512
512
LBA Sectors
117,210,240
78,140,160
Buffer Size (KBYTES)
8,192
8,192
Rotation Speed (±.1%)
5400
5400
Transfer Rate
245 – 475
199– 434
Internal (MBITS/sec.)
# of Cylinders (logical)
16,383
16,383
# of Heads
16
16
# of sec./Track
63
63
Host Transfer Rate
150MB/s
150MB/s
Seek Time (MSEC.)
Average
12
12
Track-to-track
2
2
Maximum
22
22
UNPACKING PROCEDURE
Visually inspect the shipping container prior to unpacking for any signs of damage to
the container or its contents (the carrier is responsible for any damage incurred during
shipment). The drive is a precision device and even a small drop onto any surface can
cause damage. Prior to opening the anti-static bag, it is recommended that the user
ground themself with a ground strap or by touching the PC chassis or other metal object.
Remove the drive from the anti-static bag and check it for damage. Place the drive on the
anti-static bag while configuring jumpers to avoid any electrostatic discharge. Save the
shipping container and packing material for possible use later.
INSTALLATION INSTRUCTIONS
Note: Toshiba’s 2.5” HDDs are primarily used in notebook devices. Installation into
a notebook varies depending on the system manufacturer. Toshiba’s 2.5” drives that
are installed into a desktop PC require a 3.5” installation kit.
1. Determine mounting configuration (can be mounted in either a horizontal or ver-
tical orientation).
2. Configure drive for system application.
3. When connecting the drive and host system with Serial ATA cable, use of a Serial
ATA 1.a specification compliant cable is recommended.
4. Refer to applicable manuals for software installation instructions.
Single Segment S1
Power Segment P1
Factory use
FIGURE 1 – 2.5" HDD JUMPER LOCATIONS
FIGURE 2 – MOUNTING HOLE LOCATIONS
INTERFACE CONNECTOR
Drive Side Connector
Molex RSD97799-015 or equivalent
for board
Right Angle Type: Molex 67492-0221,
67492-0222 or equivalent
for cable
Molex 88750-5318 or equivalent (for
signal). No recommendation now for power
segment.
Recommended
Host Side
Connector