English before using the appliance, Operating manual – Binatone TP-4050 User Manual

Page 7

Advertising
background image

7

ENGLISH

BEFORE USING THE

APPLIANCE

Read this operating manual which tells you

how to operate the appliance.

Before the first use of the appliance, boil

and pour out water several times.

OPERATING MANUAL

1. Place the appliance on a dry horizontal sur-
face.
2. Open the lid (3) by pulling the lid locking
valve (4) upward.
3. Fill the thermopot with water; in doing so be
careful so that water does not splash onto the
appliance casing and its electrical parts.

Attention:

Do not pour water in the thermopot from the

side where the control panel (8) is located. If water
penetrates inside the panel, this could result in failures
in the appliance operation.

4. Make sure that the water level is not above a mark “Full”on

the water level scale (2). Do not turn on the thermopot when
empty. Minimum required amount of water should not be lower
than the lowest mark on the water level scale.

Note:

If the water level is lower than the small pipe on the

heating element, the protection system preventing
waterless operation activates and the appliance is
switched off.

5. Push the lid (3) to close it.
6. Connect the detachable power cable (15) and insert the plug

into a socket with a power supply with voltage that should
comply with the data indicated on the appliance.

Attention:

Never connect the power cable if hands are wet.

7. When first connecting to a power supply, the indicator “Boil”

will light up and the thermopot will immediately start boiling.

8. Immediately after boiling the thermopot will enter the water

temperature maintenance mode. Indicator “Keep warm” will
light up.

9. To pour water out of the thermopot, press the button “Unlock”

and release the locking mode (presetting). The symbol “Un-
lock” will show that the locking mode is released. Place a cup
under the water supply port (6) and press the button “Dis-
pense”. Release the button when the cup is full. Ten seconds
later the water dispense mode will be set and the indicator
“Unlock” will go out.

10. Water can also be dispensed by using the manual pump (6).

Advertising