Something not working – Tricity Bendix TB 45 UF User Manual

Page 10

Advertising
background image

10

Problem

No power to the

appliance

The temperature in the

appliance is too high

The temperature in the

appliance is too low
Excessive frost and ice

has built up

The appliance is noisy.

Possible Cause

No power at the socket.
There is a power cut.

The fuse has blown.
Thermostat control is set at „0“.
The appliance is located in an unsuitable position.

The thermostat control is set too low.

The thermostat control is set too high.

The door has been left open.
Something is obstructing the door.
The door gasket is dirty.
The appliance is not level.

Solution

Check there is power at the socket.
Check there is not a power cut by checking the

household lights.
Check the fuse has not blown.
Check the thermostat setting.
Check the ambient temperature is within the

appliances operating limits of 16 °C to 32 °C.
Check that the thermostat control knob is turned to

the correct setting relative to ambient conditions.
Set the thermostat control knob to a lower

position.
Check the door has not been left open.
Check nothing is preventing the door from closing.
Check the door gasket is intact and clean.
Check if the appliance stands stable (all four feet

should be on the floor).

F

F

To carry out complete defrosting:

1. Disconnect the appliance from the electrical

supply. If the plug is inaccessible turn the

thermostat control knob to „0“.

2. Remove any stored food, wrap in several layers of

newspaper and store in a cool place.

3. Leave the door open.
4. Carefully draw the plastic drain spout out of the

lower part of the appliance according to the

direction of the arrow and place a tray of a suitable

size in the position shown.

5. During defrosting, push the defrost water

towards the edge of the cooling plates using a

dry cloth or a sponge. It will be collected at the

bottom of the appliance, from where it can be

diverted into the tray and then disposed of.

6. To accelerate the defrosting process place a

bowl of hot (not boiling) water inside the freezer

and close the door.

7. When defrosting is completed, dry the interior

thoroughly, replace the drain spout and close

the door.

8. Turn the thermostat control knob back to a

medium setting and leave to run for at least 4

hours with the 'fast freeze' switch on.

9. Replace the previously removed food.

Important

A temperature rise of the frozen food packs

during defrosting may shorten their safe storage

life.
Never use sharp metal tools to scrape off frost

from the evaporator as this could damage the

appliance beyond repair.

Something Not Working

If the appliance is not working correctly, please carry out the following checks before contacting your local

Tricity Bendix Service Force Centre.

If after the above checks your appliance still does not

operate correctly, contact your local Tricity Bendix

Service Force Centre.
Please note that it will be necessary to provide proof

of purchase for any in-guarantee service calls.

In-guarantee customers should ensure that the

above checks have been made, as the

engineer will make a charge if the fault is not a

mechanical or electrical breakdown.

Advertising