Tyco Power608 User Manual
Page 10
8
8
PC5508Z LED Keypad
Emergency Keys (All Keypads)
PC5508Z, LCD5500Z:
Press both * Keys for two seconds to send a
FIRE transmission.
Press both
* Keys for two seconds to send an
AUXILIARY transmission.
Press both * Keys for two seconds to send a
PANIC transmission.
* IMPORTANT NOTE (All Keypads): The Fire,
Auxiliary and Panic keys will NOT function
unless programmed by the installer. If these
keys are in service and the installer has enabled
audible feedback, holding down the key for two
seconds will cause the keypad sounder to beep
indicating that the input has been accepted and
transmission is underway.
NOTE: In the U.S.A. the [A] and
keys are
programmed to be used for non-medical
emergencies only, as per UL requirements.
Memory Light
Upon disarming, if an alarm has occurred while the
system was armed, the Memory light will turn ON
(See “Disarming the System” on page 6).
Bypass Light
If the Bypass light is ON, one or more zones are
bypassed (See “Zone Bypassing”
on page 10).
Fire Light
If the Fire light is ON, a fire alarm has occurred
(See “Fire Alarm Operation” on page 14).
Program Light
The Program light will flash when you are
programming access codes, or performing other
programming functions. If someone is
programming at another keypad, the Program light
will turn ON to indicate that the system is busy.
Display Lights (PC5508Z Keypad)