Toshiba B-SV4T-GS10-QM - Manual (Page 18)

2. PRINTER SETUP ENGLISH VERSION
2.7 Loading the Ribbon
2.7 Loading the Ribbon The printer automatically detects if a ribbon is installed after power on
and will switch to thermal transfer or direct thermal printing mode. If the
printer does not detect a ribbon (direct thermal mode), the motor that
drives the ribbon spindles will be turned off. Make sure both the ribbon
access cover and the printer top cover are closed when powering the
printer up.
1. Push down on the ribbon access cover to unlock and open the cover
2. Place a paper core on a ribbon rewind spindle.
3. Mount the ribbon rewind paper core on the front hubs.
4. Install a ribbon on the ribbon supply spindle.
5. Mount the ribbon supply spindle on the rear hubs .
6. Attach the ribbon leader to the ribbon rewind paper core.
7. Rotate the ribbon rewind paper core until the ribbon leader is
thoroughly, firmly encompassed by the black section of the ribbon.
8. Close the ribbon access cover.
Ribbon Spindle
Front Hub
Paper Core
Ribbon Access Cover
Back Hub
E2- 9