Troy-Bilt TB125QS - Manual (Page 8)

8
ASSEMBLY INSTRUCTIONS
Fig. 8
Fig. 7
Support Fitting
3. Snap the clip on to the support fitting (Fig. 7).
4. While standing in the operating position with the unit
off, adjust length to fit the operator’s size. Pull tab to
lengthen, pull strap to shorten (Fig 8).
Clip
INSTALLING THE SHOULDER HARNESS (Optional)
1. Push the strap through the center of the buckle.
2. Pull the strap over the cross bar and down through
the slot in the buckle (Fig. 6).
Fig. 6
Removing
1. Press the latching tabs on both sides of the vacuum
bag tube and pull the vacuum bag down from the
unit (Fig. 5).
2. Detach the vacuum bag from the vacuum bag hook.
Fig. 5
Latching Tabs
Vacuum Bag
Vacuum Bag Hook
Debris Exhaust Tube
Vacuum Bag Tube
Zipper
Fig. 4
Fig. 3
Latching Tabs
ATTACHING AND REMOVING THE VACUUM BAG
Attaching
1. Attach the vacuum bag to the vacuum bag hook on
the blower/vacuum tube (Fig. 3).
2. Slide the vacuum bag tube over the debris exhaust
tube on the housing. Push the tube until the latching
tabs on both sides click into place, securing the bag
on the unit (Fig. 4).
PRESS IN
PRESS IN
Clip