Toshiba C-DR0101 - Manual (Page 10)

10
AC MAINS MAIN POWER
ON
OFF
IN OUT IN OUT
VIDEO SW VIDEO IN
OUT
AUDIO GND GND 100BASE–TX
ALARM RESET OUT
ALARM IN
SW CTRL OUT
TIME SYNC IN
REC STOP IN
REC START IN
ALARM RESET IN
TIME SYNC OUT
ALARM OUT
FAILURE OUT
DISK FULL OUT
RS–232C
21 22 23 24 25 26 27 28 18 19 17 20
AC Inlet
Connect the supplied power cord to this socket.
Main Power Switch
Power switch for the Digital Video Recorder.
Video Input Terminal
Receives video signals. Connect the Multi-
switcher’s VCR output to this terminal when
connecting the Multi-switcher.
Video Output Terminal
Sends out video signals. Connect this terminal to
the Multi-switcher’s VCR input when connecting
the Multi-switcher. If the Multi-switcher is not
used, connect this terminal to the monitor to
transmit video signals to the monitor.
Switcher Video Input Terminal
Connect the Multi-Switcher’s monitor output to
this terminal. This terminal is not used if the Multi-
switcher is not connected.
Switcher Video Output Terminal
In the system in which the Multi-switcher is
connected, connect this terminal to the monitor to
transmit video signals to the monitor. Do not use
this terminal if the Multi-switcher is not connected.
Audio Input Terminal
Receives audio signals from the drive unit, etc.
Audio Output Terminal
Sends out audio signals to the monitor, etc.
Control Input/Output Terminal
Alarm Reset Output Terminal
Shorts to the ground terminal when the
Recorder’s alarm is reset.
Alarm Input Terminal
Activates an alarm by way of external sensors.
Alarm Input mode can be changed by the
Recording Setting’s Alarm Recording Setting.
Ground Terminal
Switcher Control Output Terminal
Connect this terminal to the Multi-switcher’s
switcher control input terminal.
100BASE-TX Terminal
RJ-45 terminal for Ethernet.
Control Input/Output Terminal
Alarm Reset Input Terminal
Used to permit external equipment to reset the
Recorder’s alarm operation. This terminal
provides the same operation as the front panel-
mounted Alarm Reset key.
Recording Start Input Terminal
Used to permit external equipment to initiate
recording. When the Disk Setting’s Disk Mode is
set to "SERIES," even if the Recorder’s disk is
full, the Disk Full status is reset and recording is
started.
Recording Stop Input Terminal
Used to stop recording at external equipment.
This terminal provides the same operation as the
front panel-mounted Recording key.
Time Sync Input/Output Terminals
Synchronize multiple Digital Video Recorders with
that of a specified recorder (master unit) when
two or more recorders are used. Connect the
master unit’s output to the slave unit’s input.
Alarm Output Terminal
Shorts to the ground terminal when an alarm is
activated.
System Failure Output Terminal
Shorts to the ground terminal when the hard disk
or fan failure or Video Loss occurs.
Disk Full Output Terminal
Shorts to the ground terminal when no available
hard disk time remains.
RS-232C Terminal
Connect this terminal to a computer’s RS-232C
terminal when controlling the Recorder at the
computer. Connect this terminal to the Multi-
switcher’s RS-232C terminal to synchronize the
Recorder with the Multi-switcher. (This terminal
can be connected to any of the C-MS91D, C-
MS161D Multi-switchers.)
*Ratings and serial numbers are indicated on the
bottom surface.
28
27
26
25
24
23
22
21
20
19
18
17
[Rear Panel]