Topcom TWINTALKER 7000 - Manual (Page 7)

Topcom Twintalker 7000 7
Topcom Twintalker 7000
EN
GLISH
12 Using the Twintalker 7000
12.1 Turning the Unit ON/OFF
The main switch is located on the bottom of each unit (6). Set the switch to ‘ON’ before
switching the unit on.
• To activate; press and hold . The unit will “beep” and the LCD Screen will display the
current channel, CTCSS/CDCSS code.
• To switch off; press and hold again. The unit will “beep”.
If the unit is not going to be used for a longer period, set the main switch (6) on the bottom of
the unit to ‘OFF’.
12.2 Adjusting Speaker Volume
The Speaker Volume can be adjusted using and . The Speaker Volume level is
displayed.
12.3 Receiving a Signal
The unit is continuously in the receive mode when the unit is on and not transmitting.
12.4 Transmitting a Signal
• Press and hold to transmit.
• Hold the unit in a vertical position with the microphone 10 cm from the mouth and speak
into the microphone.
• Release when you have finished transmitting.
12.5 Changing Channels
The PMR has 8 available channels.
To change channels:
• Press once, the current channel number flashes on the LCD Screen.
• Press or to change the channel.
• Press to confirm your selection and return to the NORMAL mode.
• To confirm and shift to the next option, press .
NOTE: Any PMR set on the same channel can receive and listen to the conversation.
In order for other people to receive your transmission, they
must be set on the same channel and CTCSS/CDCSS code
PTT
PTT
PTT