Operating sequence – Tricity Bendix DH 102 User Manual

Page 5

Advertising
background image

5

1.

Check the filters

Ensure they are clean and properly positioned
See "Maintenance and cleaning" section.

2.

Check that there is rinse aid and
salt

See "Before Use" section.

3.

Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.

Slide the baskets back into the machine.

4.

Ensure that the spray arms can
rotate freely.

5.

Measure out detergent

Add the required amount of detergent into the
dispenser according to the "Washing programmes"
chart.

Close the detergent dispenser lid.

6.

Close the dishwasher door

7.

Set the programme

Turn the programme selector dial clockwise until
the number of the programme you wish to select
corresponds with the programme marker on the
control panel.

8.

Start the programme

Depress the On/Off push button.

The MAINS ON indicator light will come on and the
machine will start.

If you wish to interrupt the washing programme at
any time open the door and press this button
again.

9.

At the end of the washing
programme

At the end of the programme the dishwasher will
automatically stop.

10. Switch off the dishwasher

Switch off the dishwasher by pressing the On/Off
push button.

Wait 15/20 minutes before opening the
dishwasher’s door; in this way you will avoid
burning yourself when removing the dishes
and avoid also the damage of the nearby
furniture caused by the escape of steam.

Empty the lower basket first and then the upper
one; this will avoid water dripping from the upper
basket onto the dishes in the lower one.

When the washing programme has finished, it
is recommended that the dishwasher is
unplugged and the water tap turned off.

In general it is not advisable to open the door
while the machine is working; if the door is
opened however, a safety device ensures that
the machine stops.

Important!
Care must be taken if the door is opened during
the hot phase or immediately after a
programme has finished, as steam may escape.

Operating sequence

Advertising