Team Products PMD8127 User Manual

Page 5

Advertising

12V, 14.4V, 18V

Cordless Drills

Owner’s Manual

Your drill comes with an automatic braking function that quickly stops the chuck

from turning when the trigger switch is released.
Your drill (models PMD8131 and PMD8133) has two speed ranges; low speed

(position 1) (0-400 rpm) and high speed (position 2 ) (0-1100 rpm).

Screwdriver Operation
Place the point of the screwdriver bit into the head of the screw and apply slight

pressure to the tool. Press the trigger switch slightly and then gradually increase

the drill speed. Release the trigger switch as soon as the clutch engages.
Note: Starting the drill at too high of a speed can

damage the drill bit or reduce the life of the bit.
Make sure that the driver bit is inserted straight in

the screw head or the screw may become damaged

or will not be inserted properly. When driving wood

screws, pre-drill pilot holes into the surface to make

driving easier. This will also prevent the wood from

splitting.
Note: When drilling, the drill bit can become stuck.

If this happens, a very high torque will be produced.

Always take care to hold the drill firmly to prevent

possible damage or injury.

Maintenance
Clean the Drill regularly. Before cleaning, remove the battery pack and any

accessories (bits etc.). To clean, use ONLY a mild soap and damp cloth on the

housing. Never immerse drill in any kind of fluid. Do not use any solvents or

harsh abrasives on the drill housing as this may cause damage to the unit.

Always keep the ventilation openings clear.
NOTE: All bearings in these tools are lubricated with a sufficient amount of

high-grade lubricant for the life of the unit under normal operating conditions.

No further lubrications required.
CAUTION: DO NOT keep the trigger switch pressed in with tape or any other

permanent means or the circuit will not function properly. A malfunction may

result, possibly causing overheating or damage to the unit.
Do not open the drill, battery or battery charger. There are no user serviceable

parts. Opening the unit will void the warranty.

TROUBLESHOOTING TIPS:
DRILL DOES NOT WORK?
• Recharge the battery
CHARGING INDICATOR LED NOT ILLUMINATED DURING

RECHARGING?
• Check that battery pack is properly connected to the battery charger
• Check that the AC Adaptor is properly connected at both ends

SPECIFICATIONS for PMD8127
Voltage

12V

Speed 1

0-600RPM

Torque Settings

24 + Drill

Chuck Capacity

up to 3/8”

Charger Input

120V AC 60Hz

Charging Time

Approx. 3 –8 Hours

Battery Type

Ni-Cad

SPECIFICATIONS for PMD8128
Voltage

14.4V