Texas Instruments SPRU938B - Manual (Page 27)

www.ti.com
VLYNQ Port Registers
Table 7. Control Register (CTRL) Field Descriptions (continued)
Bit Field Value Description
7 INT2CFG Interrupt to configuration register. Determines which register is written with the status contained in
interrupt packets that are received over the serial interface. Always write 1 to this bit and configure
the interrupt pointer register to point to the interrupt pending/set register.
0 Bits[31:2] of the interrupt pointer register are used to point to a system interrupt register.
1 The least significant 8 bits of the interrupt pointer register are used to point to a VLYNQ module
local register (typically the interrupt pending/set register).
6-3 Reserved 0 Reserved. Always read as 0. Writes have no effect.
2 AOPTDISABLE Address optimization disable.
0 Address optimization is enabled, eliminating unnecessary address bytes.
1 Address optimization is disabled.
1 ILOOP Internal loop back.
0 Normal operation.
1 Serial transmit data is wrapped back to the serial receive data.
0 RESET Software reset. It does not reset the VLYNQ memory-mapped registers (except for the VLYNQ
status register). You have to reprogram the VLYNQ registers if they must have a different value
after a software reset.
0 Normal operation.
1 All internal state machines are reset, the serial interface is disabled, and the link is lost.
SPRU938B – September 2007 VLYNQ Port 27
Submit Documentation Feedback