The Vollrath Co T 43R - Manual (Page 5)

T 43 & TD 43 Countertop Food Merchandiser
5. If soap or chemical cleaners are used, be sure they are completely rinsed away with clear
water, immediately after cleansing. Chemical residue could corrode the surfaces of the unit.
WARNING
ELECTRICAL SHOCK HAZARD
Do not spray outside of unit or controls with liquid or cleaning
product. Liquid could enter the electrical compartment and cause a
short circuit or electric shock.
Troubleshooting:
Symptom Possible cause and solution.
Unit will not heat The water may be too low. There is a safety
thermostat that will cut out when the water level
gets too low. The low water light will turn on and the
unit will not heat. Fill with hot water to the fill line.
Unit takes too long to heat There may be too much water in the well. The unit
is designed to be used with 2 gallons of water.
The power switch light
turns off. The unit operates
intermittently. The power switch light will cycle on and off with the
heating element. When the element is heating, the
light in the switch will be on, when the element is
not heating the light will not be on. If the "LOW
WATER" light is on, the unit will not operate until
there is water covering both elements.
Repair:
There are no user serviceable parts within this appliance. To avoid serious injury or damage,
never attempt to repair the food warmer/rethermalizer unit or replace a damaged power cord
yourself. Contact a qualified professional repair service.
17875-1 Rev A 1/04