Tascam XS-8 - Manual (Page 8)

8
TASCAM XS-8
English 3. Modification
2.4. Front Panel
v PGM 2 FADER REVERSE
Sets the direction of PGM 2 FADER operation.
NORMAL: Moving the PGM fader up makes the
volume increase.
REVERSE: Moving the PGM fader up makes the
volume decrease.
b PGM 2 FADER CURVE
Allows you to adjust the PGM 2 FADER response curve
from soft (counter-clockwise) to hard (clockwise).
n CROSS FADER REVERSE
Sets the direction of CROSS FADER operation.
NORMAL: Moving the CROSS FADER toward A
makes A signal louder and the other
way round.
REVERSE: Moving the CROSS FADER toward A
makes B signal louder and the other
way round.
m CROSS FADER CURVE
Allows you to adjust the CROSS FADER response curve
from soft (counter-clockwise) to hard (clockwise).
, PGM 1 FADER REVERSE
Sets the direction of PGM 1 FADER operation.
NORMAL: Moving up the PGM fader makes the
volume increase.
REVERSE: Moving up the PGM fader makes the
volume decrease.
. PGM 1 FADER CURVE
Allows you to adjust the PGM 1 FADER response curve
from soft (counter-clockwise) to hard (clockwise).
/
PHONES LEVEL
Adjusts the headphone output level.
! PHONES
Connect your headphone to this jack.
3. Modification
3.1. Output level
XS-8 has two MASTER outputs.
MASTER OUTPUT 1 (27): Balanced XLR connectors
MASTER OUTPUT 2 (28): Unbalanced RCA jacks
These output level is set to 0 dBV. These output levels
can be changed to +6dBV with jumpers. (See diagram
below.)
Changes on the Output Level have to be performed
by a qualified technician.
You must be careful when setting up the nominal
output level of the mixer. The "clip" display of the
connected power amplifiers must never remain
permanently lightened up, but do it occasionally by
following the rhythm of the bass signals that are
being played.
NOTE
WARNING
CONFIGURATION.
FACTORY ADJUSTED
TOP VIEW
OUT 2
OUT 1
+6dB
OUT 1 L OUT 1 R
0dB
0dB 0dB
JUMPER PIN
OUT 2 R OUT 2 L