TOA Electronics M-1264 M-1212E - Manual (Page 5)

Aux output level control [AUX]
Adjusts the level of signals going to the AUX output.
Monitor output level control [MONITOR]
Adjusts the level to transmit a signal from the stereo bus or cue bus to the monitor output and headphone output.
Cue indicator [CUE]
Lights when any cue switch is pressed, indicating that the cue bus signal is being sent to both the monitor and
headphone outputs. If the indicator is off, the stereo bus signals are sent to both outputs.
Headphone jack [PHONES]
Outputs the signal adjusted with the monitor output level control. Connect a headphone with 8 ohms or higher
impedance.
Power indicator [POWER]
Power switch
Turns on the power when this switch is pressed (the power indicator lights). To turn off the power, press this
switch again (the indicator is extinguished).
L/C/R assign switches [L/C/R]
Assign each monaural input signal to L, R, or both L and R lines of the group or stereo bus selected with the bus
assign switch _ .
Bus assign switches [ASSIGN (ST/GR)]
Assign the monaural input signal adjusted with the input level control to the stereo or group bus. (ON: group /
OFF: stereo)
Aux assign switches [AUX]
Send the input signal to the AUX bus.
Cue switches [CUE]
Send the input signal to the cue bus regardless of the position of the channel switch , allowing monitoring of the
signal at the headphone or monitor output.
Input level controls
Adjust each input signal level.
Channel switches/indicators
Send the input signal to the bus selected with both the L/C/R assign switch _ and bus assign switch © or with
the AUX assign switch . At the same time, the corresponding channel indicator lights green for monaural input
or yellow for stereo input. If the monaural channel indicator lights red, this indicates that the corresponding
compressor is activated. In such cases, adjust the input level using the input level control, as required. (The
compressor is activated when the signal level exceeds +17 dB.)