Toshiba SD-R1202 - Manual (Page 8)

2
The following steps must be performed to properly install your CD-RW/DVD-
ROM.
! Set drive’s jumpers
! Connect audio cable
! Attach IDE BUS cable
! Connect power cable
! Mount CD-RW/DVD-ROM
! Install CyberLink PowerDVD
™ software (used for viewing DVD movies)
! Install VOB InstantCD/DVD software (used for recording CDs)
SETTING JUMPERS
The mode select jumpers are six (6) straight pins located on the rear of the CD-RW/
DVD-ROM. By placing a jumper on the pins, you can select the following func-
tions:
CS: – Drive is configured using host interface signal CSEL
SL: – Configures drive as Slave
MA: – Configures drive as Master (default mode)
Mode Select Jumpers
In most installations, jumper should remain in MA (Master) position (factory
default). It is recommended that you install your CD-RW/DVD-ROM only on the
secondary IDE BUS. If you are installing on primary IDE BUS, your hard drive
would then be the Master, and you should set your CD-RW/DVD-ROM to the
Slave position (SL).
PLACING CD-RW/DVD-ROM INSIDE YOUR COMPUTER
Now that you have set your drive’s jumpers, you are ready to install your
CD-RW/DVD-ROM inside your computer.
☞ ☞ ☞ ☞ ☞
IMPORTANT: Disconnect power from your computer system before
beginning installation.
C
S
S
L
M
A