TERK Technologies Multi-Satellite Dish Antenna 1DIRECTV - Manual (Page 7)

40
50
60
70
80
90 100 110 120
130
14 0
In this example we have
for Southern California
(ZIP code 92683),
the Tilt setting is 102°.
7
DIRECTV Multi-Satellite Dish Antenna
Assembling/Adjusting
Antenna on Ground
On even ground, attach dish to the LNB Arm/Antenna Back
Assembly as shown. Leave off the Triple-head LNB until the
antenna is mounted on the mast and you’ve routed cable
through the LNB Arm.
Set Tilt Adjustment
• At the back of the antenna assembly, loosen the Tilt nuts
and then set the Tilt adjustment according to the coordinate
number you obtained in Step 1.
• Tighten the Tilt nuts. Do not change the Tilt adjustment
again from this point on (even if you could not find the
satellite signal during alignment). Unlike the Elevation and
Azimuth coordinates, there is no need to fine-tune Tilt;
doing so may cause alignment difficulty. For some of the
Eastern Seaboard states, however, there maybe an
exception: see Step 9, note #2, on page 10.
Set Elevation Adjustment
• At the side of the antenna assembly, loosen the two Elevation
nuts (one on each side) and preliminarily set the Elevation
adjustment, per the coordinate number obtained in Step 1.
• Tighten the Elevation nuts, but not completely. This
is a preliminary adjustment, which you may have to
fine-tune later on.
Attaching Antenna to Mast
• Slide the back of the antenna assembly onto the top of the
mast until it stops at the pivot bolt. If necessary, slightly
loosen the two Azimuth/Mast clamp bolts and pivot bolt so
the antenna will go on to the mast.
• Tighten the two Azimuth/Mast clamp bolts and the pivot
bolt just enough so the antenna has only side-to-side
movement (rotational swing around the mast) for later
Azimuth alignment in Step 9.
STEP
5
STEP
4
20
30
40
50
60
Azimuth/
Mast Clamp Bolts
Pivot Bolt
Dish attaching to the LNB Arm/Antenna Back Assembly
Tilt Nuts
(one shown)
Elevation Nuts,
one on each side
In this example we show
for Southern California
(ZIP code 92683), the
Elevation setting is 50°
(use the position of the
metal edge to the Elevation
scale; do not use the washer
or the bolt as reference).
Metal edge
at 50°