Toshiba MW24FN3/R - Manual (Page 26)

26
TV operation
Then press ENTER.
The unit will begin memorizing all
the channels available in your
area. Channel numbers will
remain red until auto memorizing
is complete.
Tuner setting
This unit is equipped with a channel memory feature which allows
channels to skip up or down to the next channel set into memory,
skipping over unwanted channels. Before selecting channels, they
must be programmed into the unit’s memory. In addition to normal
VHF and UHF channels, this unit can receive up to 113 Cable TV
channels. To use this unit with an antenna, set the TV/CATV menu
option to the TV mode. When shipped from the factory, this menu
option is in the CATV mode.
Press MENU. Press or to select “CH SETUP”,
then press ENTER.
Preparation:
• Press TV/VCR to select the TV/VCR mode.
1
SETUP
MENU
Press or to select “TV/CATV”. 2
ENTER
ENTER
TV/CATV selection Setting channels automatically
Notes:
• If a station being viewed stops broadcasting, the TV will
automatically shut itself off after 15 minutes.
• You can’t select “CH SETUP” if you set the channel to
“LINE1” or “LINE2”.
Press ENTER to select the “TV” or “CATV”.
The arrow indicates the selected mode.
3
Press MENU repeatedly until the menu screen
is cleared. 4
ENTER
SETUP
MENU
TV - VHF/UHF channels
CATV - CABLE TV channels
M E N U
TIMER REC SET
TV SETUP
CH SETUP
AUTO REPEAT ON OFF
SYSTEM SETUP
〈 / /ENTER/MENU 〉
CH SETUP
TV CATV
AUTO CH MEMORY
ADD/DELETE
〈 / /ENTER/MENU 〉
CH SETUP
TV CATV
AUTO CH MEMORY
ADD/DELETE
〈 / /ENTER/MENU 〉
1,3
1,4
Press or to select “AUTO CH MEMORY”. 2
3
ENTER
CH 002 AUTO
CH SETUP
TV CATV
AUTO CH MEMORY
ADD/DELETE
á / /ENTER/MENU ñ
Press MENU repeatedly until the MENU screen
is cleared. 4
SETUP
MENU
ENTER
Press MENU. Press or to select “CH SETUP”,
then press ENTER. 1
SETUP
MENU
ENTER
1-2
M E N U
TIMER REC SET
TV SETUP
CH SETUP
AUTO REPEAT ON OFF
SYSTEM SETUP
〈 / /ENTER/MENU 〉
5F10201C (E)p23-30 5/6/03, 16:51 26