Toshiba TF 610 - Manual (Page 15)

15 GB TF 610 TOSHIBA
15-03 19:56 M 100%
PROGRAM SETUP DATA
ACCESS OFF
2 x
Connection to PABX,
obtaining a public line
The TF 610 can be connected not only to
the public switched telephone network
(public line) but also to a PABX. In this
case, additional parameters have to be
entered.
With PABXs, the public line is obtained in
various ways:
• Number Dial one digit (or several
digits) in order to obtain
the public line
•Earth key Earth potential is
connected to the voice
wire(s) in order to obtain
the public line
• Flash key With this method of
obtaining the public line,
the connection circuit is
interrupted briefly.
When the method of obtaining a
public line has been entered, you
must always press the key ”❊”
before the actual number when you dial
your fax partner. This is also applicable for
saving the fax numbers (
see page 43 ).
If you have problems if your
machine is connected to an
extension, please read the
“Comments concerning connection to
PABXs” under “Further settings” (
page 56 ).
Standby mode
Start the menu
Select submenu (2x)
Make your selection
Enter function number
Confirm with ENTER
Set public line
Page through the menu...
Public line Flash: Flash function
Public line Earth key: Earth key function
Public line Digit: Code (
see next page )
...until you reach the desired menu item
Confirm with ENTER
Press STOP, return to standy
mode
Installation
Installation
STOP
ENTER
ENTER
............
PARAMETER NUMBER =_