TDK NB-59S-09S-0 - Manual (Page 4)

(3/3)
002-03 / 20120316 / ef441_nb.fm
• All specifications are subject to change without notice.
MOUNTINGS (Reference)
1.NB59S, NB-80E TYPES
The transducer can beak off if the A dimension depth is shallow.
TDK recommends a 2mm A-dimension depth and a screw tighten-
ing torque of 0.6N • m.
2.CONSTRUCTION OF NB59S
The drawing below shows an example method for transistor heat
dissipation. The attached aluminum cooling fins should fixed using
silicon rubber to a metallic water tank, etc. with sufficient head dis-
sipation capacity.
(It is recommended to use a plastic water tank. However, if a
metallic water tank is absolutely must be used, be sure to insulate
it from the power supply line.)
PRECAUTIONS
• These units are readily damaged by operation when empty
(without water). Therefore a means (float switch, etc.) should be
provided to assure operation does not occur when empty.
• Contact TDK prior to use of this unit for applications utilizing
liquids other than water.
• The unit should be used only after sufficient consideration of the
product specifications for that specific unit.
• When using units in parallel, make sure that voltage differences
do not occur between the individual transducers.
• Do not use the unit to atomize a liquid other than drinking water.
Doing so can deteriorate the transducer.
• Do not operate the transducer when the atomization unit tank is
not charged with drinking water.
• Drain water from the transducer and clean the equipment into
which the unit is incorporated if not used for a long period of
time.
• Clean the transducer periodically to prevent any degradation in
the atomizing capacity due to buildup in the transducer of such
substances as calcium, sodium, magnesium, and silicon,
commonly found in drinking water.
• TDK is not responsible for damage to the transducer resulting
from use of oscillator circuitry not supplied or not approved by
TDK.
• TDK is not responsible for worsening of unit performance
resulting from operation in environments other than those
recommended, storage in environments other than those
recommended, or use of the unit in configurations other than
those recommended by TDK for efficient mist generation.
• TDK is not responsible for the vaporization of pathogenic
bacteria or particles, not responsible if drinking water contains
substances that impede vaporization, and not responsible for
bacterial growth due to lack of a water purification function.
• Please select a plastic material of construction for the water tank
design. Metallic construction can result in electrolytic corrosion
between the chamber base and water tank.
Furthermore, if multiple units are used with the same tank, and if
each unit is equipped to be separately turned ON/OFF, the
power supply terminal for each unit should use a double-pole
switch.
Screw:M4 ×15
Rubber packing
Tank base
ш24
ш18
A
Dimensions in mm
Plastic case
(Metal case)
P.C. board Metal tank
Transducer unit
Silicon rubber
Aluminum radiation board