Troy-Bilt TBBV - Manual (Page 7)

ASSEMBLY INSTRUCTIONS
NOTE: Your unit is completely assembled as a blower in
the carton. Use the following instructions to
convert between a blower and a vacuum.
CONVERTING TO A VACUUM
1. Loosen the clamping knob on the blower housing
counterclockwise.
2. Remove the blower tube.
3. Install the bag elbow and tighten the knob clockwise
(Fig. 1).
CONVERTING TO A BLOWER
1. Remove the vacuum bag.
2. Clip the blower tube to the end of the vacuum tube
(Fig. 3).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Knob
Elbow
Vacuum Bag
Vacuum Tube
Clip
Blower Tube
Strap
Knob
Blower Tube
Assist Handle
Shaft
4. Fasten the strap to the shaft above the assist handle,
located on the powerhead (Fig. 2).
3. Install the blower tube and tighten the knob (Fig. 4).
WARNING: To avoid serious personal injury
and damage to the unit, shut unit off before
removing or installing add-ons.
7