Topcom BUTLER 1800T - Manual (Page 7)

4 USING THE BUTLER 1800T
Note:
The use of the handset depends on the base set to which the handset was registered. Some functions do not function
as described below if the DECT base set does not support these functions. Especially the functions ‘caller identification’
and ‘unanswered call list’ depend on the base set type.
4.1 Switching the Butler 1800T on and off
You can switch off the BUTLER 1800T to save batteries by pressing and holding the OK key for 3 sec-
onds. Repeat this procedure to switch the phone on again.
4.2 Receiving Calls
4.2.1 Internal Call
• If you call your BUTLER 1800T from another handset, the internal
calling number appears on the display.
• Pick up the handset and you are connected to the caller.
4.2.2 External Call
• On an external call the external calling number appears on the
display if your DECT base supports this function.
• Pick up the handset and you are connected to the caller.
4.3 Making External calls
4.3.1 Normal Procedure :
• Pick up the handset.
• Dial the phone number of your choice.
4.3.2 Block Dialling :
• Dial the number of your choice.
• You can delete an entry by pressing the ESC key
• Pick up the handset.
• The phone number will be dialled, wait for a connection to be
established.
4.4 Making Internal Calls
•
Press the INT key.
• Enter the number of the internal handset you want to call.
• Wait for a connection to be established.
Note : When pressing the INT key, you will not hear a dial tone.
Butler 1800T
7
INT
Interna l ca ll
2
EXT
Exte rn al call
0 1 6 2 3 4 5 7 8
EXT
0 0 3 2 4 5 7 8 9 5 6 9
0 0 3 2 4 5 7 8 9 5 6 9
IN T
In ternal call
3