Tmb programmable multiband amplifier – Triax TMB 10A User Manual
Page 4
4
TMB Programmable Multiband Amplifier
TMB 10A
•
TMB 10B
•
TMB 10S
GB
S
S
S
a
a
a
f
f
f
e
e
e
t
t
t
y
y
y
I
I
I
n
n
n
s
s
s
t
t
t
r
r
r
u
u
u
c
c
c
t
t
t
i
i
i
o
o
o
n
n
n
s
s
s
Important: The unit should only be opened by a qualified technician.
• Disconnect the unit before carrying out any work on it, as some powered components are
dangerous (risk of electrical shock).
• To maintain the temperature of the unit within its normal operating range, ensure the free
circulation of air around the unit (avoid placing it in enclosed spaces). The ventilation grids must
be free of any obstruction.
• Ensure that no liquids can penetrate inside the unit (splashes and/or run off).
• Do not install the unit in a damp place. If there are traces of condensation on the unit, do not use it
until it has dried completely.
• The mains power cable and the HF connection cables must be in good condition and free to move
(neither crushed nor obstructed).
• The mains plug, easily accessible for the technician, must be out of reach of children.
Earthing the unit
• Your aerial installation must comply with the requirements specified by the European provisions
EN 50083 (conformity of collective installations) and EN 60065 (standards in force for electrical
protection).
Replacing fuses
• Only a qualified technician can replace defective fuses.
Electromagnetic compatibility (EMC)
• Ensure that the screws on the box are properly tightened.
• Cables and connection terminals should show no signs of rust.