TRENDnet TE100-PIP - Manual (Page 12)

Installing the Print Server
Follow these steps for a trouble-free start of print server operations
with your pocket-sized Print Server.
1. Confirm proper operation of the printer to be connected to the print
server.
2. When you have confirmed proper operation of the printer, turn off
the power.
3. Confirm that your network is operating normally.
4. Connect the print server to the network (through the RJ-45
connector of the print server).
5. While the printer is powered off, connect the print server to the
printer’s port.
6. Turn on the printer’s power.
7. Connect the DC end of the AC Power adapter to the DC power
input socket of the print server and the AC end to the wall outlet.
This will supply power to the print server immediately.
NOTE: This print server is built with a default IP Address. To
prevent from any conflict in your network, it is recommended to
use the PS-Utility program to change the IP setting when there is
some other device’s IP Address is the same as the print server’s
default IP Address.