Toastmaster 999201U - Manual (Page 3)

3
n o t c h e s should protrude from the back and be parallel with the leg of the
housing.
5. Place the blade on the auger with the cutting edge facing outward. Then put
the disk on by aligning the notch on the outer edge of the disk with the pin on
the inside of the housing, and twist ring onto housing. Make sure all parts fit
together securely.
6. Attach the assembled grinder by inserting the notches on the auger into the
drive slots of mixer drive mechanism “a”, (see figure 3).
7. Turn counterclockwise until meat grinder locks into place . Note the directions
of the arrows on the meat grinder. Firmly tighten the ring, (see figure 1).
8. Attach the food tray to the top of the meat grinder body and fill with food, do
not over-fill. Place a plate under the grinder.
9. To start the meat grinder, turn the speed control dial to Speed 4.Use the food
pusher to guide the food down into the grinder.
NOTE: If food does not go through easily, it may be necessary to stop and clean
the grinder. Turn Off and unplug.Remove ring, disk, and blade, clean out food and
reassemble.
10. When finished, turn speed control dial to Off position.
11. To help clean the grinder body of remaining food, put 1-2 slices of bread
through the grinding process.
CARE AND CLEANING
1. Turn stand mixer to Off position and unplug.
2. B e fore first use or immediately after each use, disassemble all parts fo r
c l e a n i n g .
3. Remove food tray, lift up on latch and turn meat grinder clockwise and remove,
use the arrows on the meat grinder as a guide, (see figure 1).
4. After loosening the ring, remove the disk, blade and auger from housing of
meat grinder.
5. Carefully wash all parts in wa rm, sudsy wa t e r. Rinse and immediately dry
t h o r o u g h l y. Do not use abrasive cleaners on any part of the food processor.
6. Coat blade and disk with vegetable oil.
7. See stand mixer use and care guide for further cleaning instructions.
A ny servicing disassembly other than the above cleaning should be per-
fo r m e d by an authorized service center. Failure to follow this instruction may
result in a fire, electric shock or injury to persons.