Toastmaster AACU-MISER AM24SS - Manual (Page 9)

SECTION 2
INSTALLATION
5
A. Shipping Damage Inspection
IMPORTANT
IT IS THE CUSTOMER’S RESPONSIBILITY TO
REPORT ANY CONCEALED OR NON-
CONCEALED DAMAGE TO THE FREIGHT
COMPANY.
1. All shipping containers should be examined
for damage before and during unloading. This
equipment was carefully inspected and
packaged at the factory. The freight carrier
has assumed responsibility for its safe transit
and delivery. If the equipment is received in a
damaged condition, either apparent or
concealed, a claim must be made with the
delivering carrier.
2. Apparent Damage or Loss - If the damage or
loss is apparent, it must be noted on the freight
bill or on the express receipt at the time of
delivery, and must be signed by the carrier’s
agent (the driver). If this is not done, the carrier
may refuse the claim. The carrier will supply
any necessary claim forms.
3. Concealed Damage or Loss - If damage or
loss is NOT apparent until after the equipment
is unpacked, a request for inspection of the
concealed damage must be made with the
carrier within 15 days. The carrier will make
an inspection and will supply necessary claim
forms. Be certain to retain all contents plus
external and internal packing materials for
inspection.
B. Unpacking
The griddle is delivered in a carton that is fastened
to a wooden shipping pallet.
WARNING
USE CAUTION WHEN CUTTING THE
BANDING STRAPS. WHEN CUT, THE
STRAPS MAY SNAP AWAY FROM THE
CARTON.
1. Cut the banding straps that hold the carton in
place. Lift the carton up, and remove it from
over the griddle.
2. Carefully turn the pallet - with the griddle still
mounted atop it - upside-down. Remove the
bolts that fasten the pallet to the griddle.
3. Remove the pallet from the griddle.
4. Retain all shipping materials until it is certain
that the griddle has not suffered concealed
shipping damage.
C. Installation
NOTE
IF INSTALLING THE GRIDDLE ON A STAND,
CONSULT THE STAND INSTRUCTIONS FOR
THE INSTALLATION PROCEDURE. ENSURE
THAT THE LOCATION OF THE STAND ALLOWS
SUFFICIENT CLEARANCE FOR THE GRIDDLE,
AS SHOWN IN THE DIAGRAM BELOW. THEN,
PROCEED TO STEP D,
ELECTRICAL
CONNECTION.
IF INSTALLING THE GRIDDLE ON A
COUNTERTOP, PROCEED WITH THE
INSTRUCTIONS BELOW.
1. Installing the Spacer Brackets and Legs
a. Check that the griddle is still upside-down
from unpacking.
b. Place the two spacer brackets along the
side edges of the bottom plate of the Accu-
Miser. The holes in the brackets should
align with the weldnuts on the bottom
plate. The flanged edge of the brackets
should face the
outside of the griddle, with
the flange itself facing up.
c. Locate the four 4” adjustable legs and
thread them into the weldnuts on the leg
mounting plates. This holds the two
spacer brackets in place. Tighten the legs
until they are secure against the spacer
brackets.
2. Leveling the Griddle
a. Carefully lift the griddle onto its legs, and
place it on the counter in its permanent
position.
b. Check that the proposed location for the
griddle provides sufficient clearance, as
shown in the diagram below. If not enough
clearance is provided, relocate the griddle
as necessary.
Minimum External Clearances