Thermador DW44ZSB - Manual (Page 15)

EN- GLISH
Thermador Dishwasher Model DW44Z www.thermador.com
Cycle Interruption
As a safety feature the dishwasher will automatically
turn itself off whenever the door is opened. However,
if the door is opened quickly while in a wash or rinse
cycle some water may splash out of the dishwasher.
For this reason it is recommended that the machine
always be switched off before opening the door.
Changing a Cycle
To change the cycle selection, press the program but-
ton of the desired cycle TWICE. The chosen cycle
button (or the light above it) becomes illuminated,
showing that it has been selected.
Interrupting, Changing or Canceling a Cycle
1. Push the on/off button and close the door.
To Interrupt a Cycle
1. Press the on/off button to stop operation.
2. Wait at least 10 seconds (or until the water noises
stop) before opening the door.
To Resume a Cycle
WARNING
DO NOT PULL DOOR FULLY
OPEN WHILE DISHWASHER IS
IN OPERATION. QUICKLY
OPENING THE DOOR WHILE
DISHWASHER IS IN OPERATION
COULD RESULT IN SERIOUS
SCALDING.
Figure 20
Figure 21
Figure 22
ON/OFF BUTTON
CHANGE CYCLE
CANCEL CYCLE
Page 13
On
Off
Clean
Refill
Rinse
Agent
Upper
Wash
Heavy
Wash
Normal
Wash
Light
Wash
Rinse
Only
• — Cancel Clean — •
Clean
Refill
Rinse
Agent
Upper
Wash
Heavy
Wash
Normal
Wash
Light
Wash
Rinse
Only
• — Cancel Clean — •
Canceling a Cycle
1. Press the cancel drain buttons at the same time
and hold for approximately 3 seconds.
2. When the drain pump noises stop and the LED
display or clean light indicate that the end of the
cycle has been reached, the dishwasher is reset.
3. Press the on/off button to turn the dishwasher off.
4. The dishwasher is now ready to run a selected
cycle. Add more detergent if necessary.