Tunturi E5R User Manual

Page 5

Advertising
background image

G B

5

O W N E R ' S M A N U A L • E 5 R

These are average values and the maximum varies

from person to person. The maximum heart rate

diminishes on average by one point per year. If you

belong to a risk group, ask a doctor to measure

your maximum heart rate for you. We have defined

three different heart-rate zones to help you with

targeted training.
Beginner: 50-60 % of maximum heart rate

Also suitable for weight-watchers, convalescents

and those who haven’t exercised for a long time.

Three sessions a week of at least a half-hour each

is recommended.
Trainer: 60-70 % of maximum heart rate

Perfect for improving and maintaining fitness. You

should train for a minimum of 30 minutes at least

three times a week. To improve your condition still

further, increase either frequency or effort, but not

both at the same time!
Active trainer: 70-80 % of maximum

heart rate

Exercise at this level suits only the fittest and

presupposes a long history of exercising.

M E T E R

TURNING THE METER ON AND OFF

The meter turns itself on when the device is

connected to the mains current. When the meter

has not been used for five minutes (no heart

rate registered, no keys pressed, no pedaling), it

automatically switches itself to energy-saver state.

The meter is returned to its active state by pressing

any key, starting to pedal or sending heart-rate

signals to the unit. When you restart, the meter

automatically starts from Mode function.

Protect the meter from excess sunlight,

because that may fade the interface box and surface

membrane colors. Please also be careful not to

allow the meter to come into contact with water. A

sharp blow may damage the meter.

PULSE MEASUREMENT

WITH HAND GRIP PULSE

NOTE !

The hand grip pulse measurement

functions with the transmitter box switch in

ON

position. If you wish to use the Polar belt for heart

rate measurement, switch the hand grip pulse to

OFF

position.

Pulse is measured by the hand grip sensors in

the handle bars. Pulse is measured when the user of

E5R

is touching both sensors simultaneously. Pulse

measurement requires that the skin is constantly

touching the sensors and that the skin is slightly

moist.

NOTE !

If you use a heart rate controlled

exercise or if the accuracy of heart rate information

is important to you, we recommend heart rate

measurement with the Polar belt; unlike with the

heart rate belt, the accuracy of pulse measurement

may vary considerably from person to person.

HEART RATE MEASUREMENT WITH

THE HEART RATE BELT

1.

Attach the transmitter to the elastic strap.

2.

Adjust the length of the strap to fit snugly and

comfortably.

3.

Pull the transmitter away from your chest and

wet the grooved areas at its back.

4.

Check the wet electrodes are uniformly

positioned next to your skin and that the Polar logo

is central and upright.

The heart rate belt works best when the

transmitter is worn against your bare skin. If you

prefer to wear it over a shirt, please moisten the

shirt well under the electrodes: the contacts must

be wet while you exercise.

Take good care of the transmitter after you

exercise. This helps to prolong the life of the

electrodes and battery.

1.

Wash the transmitter carefully with a mild

soap-water solution.

2.

Rinse with clean water.

3.

Dry the transmitter carefully.

F U N C T I O N K E Y S

MODE

includes constant resistance, constant effort

and constant heart-rate workouts. The user

interface automatically starts from the constant

resistance workout. Use the operation key

SET

to

make settings and adjustments to the user interface

options.

PROG

includes pre-programmed exercise

profiles, memory positions for your self-designed

exercise profiles and measurement of recovery

pulse.

REC AND OK

Use the Rec key to save your own workouts. Press

Rec before beginning the workout you wish to

save. Press

OK

to confirm.

RESET

Press the Reset key for more than one second to

display the cumulative values. Pressing Reset always

resets the value on the display.

SETTING KEYS -/+

Use the setting keys (-/+) to adjust resistance, effort

and heart rate for the workout.

Advertising