Technika MC123 - Manual (Page 4)

Switch the function selector to ‘CD’. The clock UNPACKING
must be set when the selector is in this position.
T he carton contains:
The power light comes on and the
! The MC-123 AM/FM/CD Micro System. display lights up.
! One pair of loudspeakers: Example: set the time to 3:40 pm.
Unpack and inspect the components carefully. If The Time Setting buttons are on the rear panel.
any item is damaged or missing, contact the Tesco
Press and hold the TIME SET
store from where you purchased this product, or if
button.
that is not possible, your nearest Tesco store. Please
Hold down the Time Set button
have your receipt ready when you call.
and press the HOUR button to set
Retain the packaging. If you dispose of it, do so in
the hours. When the time goes
accordance with recycling regulations in your area.
past 12:00, the display moves When running speaker cables, keep them away
Retain the User Handbook. If you pass the unit on to from AM to PM. from areas whey they could cause danger.
a third party make sure you pass on the handbook. You will get better stereo if the speakers are placed
some distance from each other.
PREPARATION
Remove any strips of tape holding the CD door.
Press the DOOR OPEN button to open the CD lid.
Standby and Power Off
Check that the mains voltage on the rating plate is Carefully remove the protective card from the CD
When power is connected and the rear panel power the same as the voltage in your area. mechanism. Close the CD door and discard the
switch is on, switching the Function Selector on the card and the pieces of tape. Switch the Power Switch on the rear
front panel to “off” sets the unit into standby. In
panel to the “0" - OFF position. SITING AND PLACEMENT
Standby the unit power consumption is below 1
Make sure there is a suitable power point within Switch the FUNCTION SELECTOR to OFF. Watt and the front panel is powered at a very low
easy reach. level, with no backlight. Uncoil the AC power cord, plug the cord into
The only point of leaving the unit in standby is to The means of disconnection of the appliance is the the wall socket and switch on the mains power.
power the clock. As there are no other settings you mains plug. This must not be obstructed and must Switch the Power Switch to the “I” ON position.
can switch the unit off at the rear panel if you wish be freely operable at all times. The system will now go to Standby. In Standby the
but you will have to reset the clock (if required) when
display will light up very faintly and the clock time is Site the system on a stable surface (ideally a stout
you switch on again.
just visible but no controls are operable. shelf) where it is unlikely to fall or get knocked over.
If you are not using the unit for some time always set
The speakers which should be placed on either side You may now set the clock time if you wish but
the rear panel switch to OFF for safety.
of the main unit with at least150mm between each this is optional. No control functions are
speaker and the main unit. affected if you choose not to set the time.
! Plug each loudspeaker into the loudspeaker
connectors of the main unit as shown in the
diagram below. Plug the connectors in firmly but do
not use excessive force.
!
!
! Hold down the Time Set button
and press the MINUTE button to
set the minutes.
! Release the Time set button.
!
!
!
!
!
PRELIMINARIES REMOTE HANDSET
4
LOUDSPEAKER CONNECTION
RIGHT SPEAKER LEFT SPEAKER
SPEAKERS
R L
CONNECTING THE MAINS
REMOTE HANDSET SETTING THE TIME
TIME SET
HOUR
MINUTE
:
3 40
FM
PM
:
I2 00
AM
FM
PM