Telular Wi PATHTM SX7T Terminal and SX7M Modem EVDO - Manual (Page 7)

5. Connect the Ethernet (RJ-45) cable to the Ethernet Port on the SX7. (This cable will
serve as the connection to your computer in most configurations, including the primary
Wireless WAN data connection.)
7. Depending on your usage needs, connect RJ-11 phone cables to the Phone (J1) and
Phone/Fax (J2) ports (SX7T only).
Connect the SX7 to Your Computer
Before you connect your computer, ensure you do not have an existing landline data
connection and that you have either Internet Explorer or FireFox Web browser installed on
your computer.
Connect the Ethernet (RJ-45) cable from the SX7 to an available Ethernet port on your
computer.
Note
It is recommended that you use the Ethernet connection for your primary Wireless WAN data
connection; however, you may also use Dial-Up Networking (DUN) using the supplied USB cable
(see
“Using the USB Connection Option” on page 12). Before connecting with a USB, install
the SX7 USB drivers included on the CD that was packaged with your device (see “Install the
USB Drivers” on page 12).
Ethernet Port
Phone (J1) Phone/Fax (J2)
Note
The Phone (J1) and Phone/Fax (J2) RJ-11 ports are only available on the SX7T terminal model.
See “Using the Voice and Fax Options (SX7T Only)” on page 16 for information about setting
up your RJ-11 Phone and Phone/Fax jacks.
Note
It is recommended that you use the Ethernet connection for your primary Wireless WAN data
connection; however, you may also use Dial-Up Networking (DUN) using the supplied USB cable.
Wi PATH TM SX7 5 User Guide
Getting Started