TOA Electronics HS-1500WT - Manual (Page 7)

7
8.3. Using as a Floor Monitor
Notes
• When installing the speaker system on slippery floor,
put a non-slip mat under the speaker.
• Do not kick or stand on the speaker system, as this
will damage the speaker.
The figure shows the HS-1200 series.
8.4. Attaching the Supplied Rubber Feet
Attach the rubber feet in the case of speaker storage or
on-floor speaker installation.
Note
The rubber foot has a direction (back and forth).
Align the datum line on the rubber foot with the positioning
mark (
) on the speaker unit as shown at right.
Datum line
Positioning mark
Rubber foot
(accessory) Screw M6 x 30 (accessory)
8.5. Attaching a Handle
The speaker system comes with a handy carrying handle.
Attach the handle on the speaker's top surface.
Screw M6 x 30
(accessory)
Handle fitting bracket
(accessory)
Handle
(accessory)
9. EQUALIZING BY THE DIGITAL SIGNAL PROCESSOR
The speaker system is capable of providing high-efficiency and wide range reproduction without using an
equalizer, however more clear and dynamic sound quality can be reproduced by using our digital signal
processor and performing its settings as shown in the tables below.
[For the HS-1200BT and HS-1200WT] [For the HS-1500BT and HS-1500WT]
Filter Frequency (Hz) Gain (dB) Q
HPF (12 dB) 50 1.432
PEQ 520 -4.0 1.414
PEQ 1600 -2.0 5.764
PEQ 2300 -4.0 5.764
PEQ 5000 -2.0 1.011
PEQ 14000 +3.0 1.204
Filter Frequency (Hz) Gain (dB) Q
HPF (12 dB) 50 1.274
PEQ 530 -3.5 2.145
PEQ 1300 -3.0 2.871
PEQ 2500 -3.0 2.871
PEQ 4500 -3.5 1.011
PEQ 14000 +1.5 0.718