Toshiba 386SX User Manual
Page 56
AR-B1375/AR-B1376 User s Guide
7-4
System Keyboard
This function specifies that a keyboard is attached to the computer.
Primary Display
The option is used to set the type of video display card installed in the system.
Password Check
This option enables password checking every time the computer is powered on or every time the BIOS Setup is
executed. If Always is chosen, a user password prompt appears every time the computer is turned on. If Setup is
chosen, the password prompt appears if the BIOS executed.
Parity Check
Set this option to Enabled to check the parity of all system memory.
Wait for ‘F1’ If Error
AMIBIOS POST error messages are followed by:
Press <F1> to continue
If this option is set to Disabled, the AMIBIOS does not wait for you to press the <F1> key after an error message.
Hit ‘DEL’ Message Display
Set this option to Disabled to prevent the message as follows:
Hit ‘DEL’ if you want to run setup
It will prevent the message from appearing on the first BIOS screen when the computer boots.
Hard Disk Delay
If this option is set to Disabled, and the system BIOS executes too fast the result may be that the BIOS can’t find
the hard disk drive. Use caution when setting this option.
On Board Flash Disk
This item is used to activate the FLASH on this CPU board.
Shadow
These options control the location of the contents of the 32KB of ROM beginning at the specified memory location.
If no adapter ROM is using the named ROM area, this area is made available to the local bus. The settings are:
SETTING DESCRIPTION
Disabled The video ROM is not copied to RAM. The contents of
the video ROM cannot be read from or written to cache
memory.
Enabled The contents of C000h - C7FFFh are written to the same
address in system memory (RAM) for faster execution.
Cached
The contents of the named ROM area are written to the
same address in system memory (RAM) for faster
execution, if an adapter ROM will be using the named
ROM area. Also, the contents of the RAM area can be
read from and written to cache memory.
Table 7-8 Shadow Setting
OnBoard IDE
This option specifies the onboard IDE controller channels that will be used.