Tivoli Audio iYiYi Sound System - Manual (Page 11)


English
Using the Alarm:
TO SET THE ALARM TIME: (the clock must be set before the alarm can be set.) Briefly press
the Alarm Button. The ALARM icon will flash on the display. Then press and hold the clock
set button until a beep indicates that you’re in the set mode and the hour will flash (Fig. ).
Rotate the Tune knob (which also determines AM or PM) clockwise to increase hour, counter
clockwise to decrease the hour. There is no “AM” designation for morning hours. Now press
the Tune knob in to set the hour, and then adjust the minutes in the same manner (Fig. ).
The minutes will not affect the hour setting. Press the Tune knob again to save the settings
(Fig. ). Press the Alarm button briefly to see the current Alarm time. The “ALARM” icon will
blink when displaying alarm time.
Note: Non-US models use a -hour clock format.
SETTING THE ALARM TO WAKE: After setting the alarm time, press and hold the Alarm
button until a beep is heard and the word “Alarm” shows on the display. When the alarm is
set to wake it will activate to the last source and volume level used prior to the iYiYi being
turned off. If the iYiYi was last used in auxiliary mode, a beep will sound when the alarm
activates. The volume level of the beep cannot be changed.
TO RE-SET THE ALARM FOR THE NEXT DAY: After the alarm activates, press the Alarm
button to re-set the alarm for the following day. “OFF” and “ALARM” will flash on the display,
the system will shut off, and the current time will be displayed.
1.
2.
3.
Figure  Figure  Figure