Toastmaster 999202U - Manual (Page 4)

4
8. Plug stand mixer into 120 V ~ 60 Hz outlet.
9. To start food processor, turn the speed control dial to any speed (1-4).If using
a disk, use the food pusher to push the food down into the bowl with light pres-
sure.
NOTE: Do not fill food above the hole on the stem of the blade or above the bot-
tom of the disk holder, (see figure 5).
10. Turn the speed control dial to the Off position to stop action and wait for
blade/disk to stop rotating before removing food processor.
NOTE: The cover cannot be removed from the bowl until the food processor is
removed from the stand mixer.
11. Grasp handle of food processor and remove from stand mixer base by turning
clockwise. Remove lid, blade or disk and disk holder.
12. Remove processed food from the bowl using a rubber spatula.
CARE AND CLEANING
CAUTION: Blade and disks are sharp. Handle carefully.
1. Turn stand mixer to Off position and unplug.
2. B e fore first use or immediately after each use, disassemble all parts for cleaning.
3. Carefully wash all parts in warm, sudsy water. Rinse and dry thoroughly. Do
not use abrasive cleaners on any part of the food processor. All parts except
the handle may be washed on the top shelf of your dishwasher. Be sure that
the parts are not wedged in the racks as they may warp. Also, make sure that
the chopping blade is placed so that the cone opens dow n ward to preve n t
d a m a g e to other items.
4. Clean the handle using a damp cloth.
5. See stand mixer use and care guide for further cleaning instructions.
A ny servicing disassembly other than the above cleaning should be per-
fo r m e d by an authorized service center. Failure to follow this instruction may
result in a fire, electric shock or injury to persons.
DO
• Most foods require only seconds, not minutes, to process.
• For even slices, fill the feed tube as tight as possible. If food is allowed to lean to
one side, you’ll get diagonal slices .
• Break or cut food into uniform 1-1 1 ⁄
2
inch pieces before processing with the blade.
This will allow the food to drop down around the blade for faster more thorough
chopping action.
• To add foods while processor is in operation, use the feed tube and food pusher.
• Process food with the blade for a short time for smaller amounts or coarser chop-
ping. Process for longer times for larger amounts or finer chopping.
• Always remove bones, pits, hard shells, seeds and cores before processing to
avoid damage to the unit.