Tascam PA-30 - Manual (Page 10)

Output power at 8 ohms, (1 kHz):
30 Watts minimum RMS per channel in stereo
mode, both channels driven. (0.05% THD)
60 Watts minimum RMS in BTL (monophonic)
mode. (0.08% THD)
Total Harmonic Distortion (1 kHz):
0.05% (30 Watts 8 ohms, STEREO)
0.08% (60 Watts 8 ohm, BTL)
Intermodulation Distortion:
Less than 0.2%, 70Hz: 7kHz (4:1)
Frequency Response:
20 Hz to 20 kHz, +0, 1 dB at rated power output.
Damping Factor:
80 minimum, 8 ohm load. 20 Hz to 20 kHz.
Input Impedance and SensItivity:
–10dBV (0.3 volt RMS) for rated output, 15 kohm
unbalanced at RCA input.
+1.3 dBu (0.9 volts RMS) for rated output, 40
kohm balanced at XLR input.
Hum and Noise:
85 dB below rated output.
Minimum Load Impedance:
8 ohms per channel, stereo mode.
8 ohms, BTL mode.
Protection Circuits:
DC balance voltage protector; electronic output
power overload protector
Semiconductor Complement:
9 transistors, 8 diodes, 2 integrated circuits,
3 LEDs.
Power Requimments:
120/230 volts, 50/60 Hz, AC switchable;
8 Watts at idle, 130 Watts at rated output.
Weight:
4.5 kg net; 5.5 kg in shipping carton.
Physical Dimensions:
2.1" (54 mm) high, 19" (482 mm) wide, 10.9" (276
mm) deep.
NOTES:
Specifications subject to change without notice.
0 dBV is referenced to 1 volt RMS.
0 dBu is referenced to 0.775 volt RMS.
10
TASCAM PA-30
Specifications