Toro 14AP80RP744 - Manual (Page 19)

19
Parking Brake Adjustment
WARNING: Never attempt to adjust the
brakes while the engine is running. Always
disengage PTO, move shift lever into neutral
position, stop engine and remove key to
prevent unintended starting.
If the tractor does not come to a complete stop when
the brake pedal is completely depressed, or if the
tractor’s rear wheels can roll with the parking brake
applied, the brake is in need of adjustment. The brake
disc can be found on the right side of the transmission
in the rear of the tractor. Adjust if necessary as follows:
• Looking at the transmission from the right side of
the tractor, locate the compression spring and
brake disc. See Figure 11.
Figure 11
• Loosen, but do NOT remove, the hex nut found on
the right side of the brake assembly. See Figure 11.
• Insert a feeler gauge (set at .011”) between the
brake disc and the brake puck.
NOTE: If a feeler gauge is unavailable, a typical
business card is approximately .011” thick.
• Retighten the hex nut loosened earlier, leaving a
.011” gap between the brake disc and the brake
puck.
Seat Adjustment
To adjust the position of the seat, loosen the two knobs
on the bottom of the seat. Slide the seat forward or
rearward as desired. Retighten the two knobs.
Steering Adjustment
If the tractor turns tighter in one direction than the other,
or if the ball joints are being replaced due to damage or
wear, the steering drag links may need to be adjusted.
Adjust the drag links so that equal lengths are threaded
into the ball joint on the left side and the ball joint on the
right side:
• Loosen the jam nut found on the drag link at the
rear of the ball joint. See Figure 12.
Figure 12
• Remove the hex nut on the top of ball joint. See
Figure 12.
• Thread the ball joint toward the jam nut to shorten
the drag link. Thread the ball joint away from the
jam nut to lengthen the drag link.
• Replace hex nut and lock washer and retighten the
jam nut after proper adjustment is achieved.
NOTE: Threading the ball joints too far onto the drag
links will cause the front tires to "toe-in" too far. Proper
toe-in is between 1/16" and 5/16".
Front tire toe-in can be measured as follows:
• Place the steering wheel in position for straight
ahead travel.
• In front of the axle, measure the distance
horizontally from the inside of the left rim to the
inside of the right rim. Note the distance.
• Behind the axle, measure the distance horizontally
from the inside of the left rim to the inside of the
right rim. Note the distance.
• The measurement taken in front of the axle should
be between 1/16" and 5/16" less than the
measurement taken behind the axle.
• Adjust if necessary.
Spring
Hex Nut
Brake Disc
Brake Puck
Hex Nut
Jam
Nut
Ball
Joint
Drag Link