Toshiba W-701 - Manual (Page 18)

1 8
To add channels
To erase channels
Adding or erasing channels
Adding channels
If a desired channel cannot be scanned
automatically because of a weak signal, it can be
added to the memory.
Erasing channels
You can erase a stored channel from the memory
if it is unnecessary.
1) Follow steps 1 to 3 of “Incoming Antenna/CATV
Signals”.
2) Select “ADD CH” or “ERASE CH” using PLAY/X2
or STOP.
3) Enter a channel number of 1 to 125 using
number buttons.
For more than 100 number, first press
100.
For CATV channels, refer to the chart below.
(For other orders, check with your cable
company.)
4) Repeat steps 2) and 3) to add or erase
channels as necessary.
5) Press PROG. to exit.
Selecting stored channels
Once the active channels have been stored, you
can select the channels in two ways below.
Number buttons
To enter digits of the channel number.
• For one-digit number, enter 0 before.
• For more than 100 number, first press
100.
• Each number button needs to be pressed
within 2 seconds.
CH/TRK
To shift up or down the stored channel numbers.
PROG
TV TV A C
n O
n O
n
O
FF O
O SET CH
PUSH ~9 0 EYS K
T
– –
– –
TV / C T A V
AUTO SCA n
ADD CH
ERAS
C E H
E D: n
SET UP PRESET PROGRAM
PROG
TV TV A C
n O
n O
n O
FF O
O SET CH
PUSH ~9 0 EYS K
T
– –
– –
TV / C T A V
AUTO SCA n
ADD CH
ERAS
C E H
E D: n
SET UP PRESET PROGRAM
Storing Channels on the VCR (continued)
Cable Box/DSS Output Channel
Setting
To set the Cable Box/DSS output Channel on the
VCR.
1) Press PROG. to display the MENU screen.
2) Select “PRESET” using FF or REW, and press
ENTER.
3) Select “CABLE BOX/DSS” using PLAY/X2 or
STOP, and press ENTER.
4) Select “NO”, “C.BOX” or “DSS” using FF or REW
according to your connection type.
5) If set to “C.BOX” or “DSS”, select “OUTPUT CH”
using PLAY/X2 or STOP. Then enter the output
channel number of your cable box (Usually 3 or
4, check the rear of the cable box.) or line input
mode “L1” using the
I.SELECT button according
to your connection.
6) Press PROG. to exit.
PROG
C . BOX O n S S D USE
E D: n
SET UP PRESET PROGRAM
PROG
C . BOX S S D
H C 3
O SET CH
PUSH ~9 0 EYS K
T
USE
OUT UT CH
P
E D: n
SET UP PRESET PROGRAM
O n