Sony KV-32CS71K - Manual (Page 5)

Overview 5
Overview of Remote Control Buttons
GB
1 To Temporarily Switch Off TV: Press to temporarily switch off TV
(standby indicator
on TV lights up). Press again to switch on TV
from standby mode. To save energy we recommend switching off
completely when TV is not in use.
After 15 minutes without a signal and without any button being
pressed, the TV switches automatically into standby mode.
2 Selecting input source: Press repeatedly until the desired input
symbol of the source appears on the TV screen.
3 Selecting channels: Press to select channels. For double-digit
programme numbers, enter the second digit within 2.5 seconds.
4 Press to watch the last channel selected (watched for at least 5
seconds).
5 This button only works in Teletext mode.
6 This button only works in Teletext mode.
7 Selecting Teletext: Press to switch on teletext.
8 When MENU is switched on, use these buttons to operate the menu
system. For details refer to “Introducing and Using the Menu System”
on page
9 .
When MENU is switched off, press OK to show a channel overview.
Then press
v or V to select the channel and then press the OK button
to watch the selected channel.
9 Selecting Screen format: Press this button repeatedly to change
the screen format. For more details refer to ‘Auto Format’ on page 15.
q; Selecting channels: Press to select the next or previous channel.
qa Muting the Sound: Press to mute TV sound. Press again to restore
the sound.
qs Adjusting TV volume: Press to adjust the volume of the TV.
qd Displaying the menu system: Press to display the menu on the TV
screen. Press again to remove the menu display from the TV screen.
qf Selecting TV mode: Press to switch off teletext or video input.
qg Selecting Picture mode: Press repeatedly to change the picture
mode.
qh Selecting Sound mode: Press repeatedly to change the sound
mode.
qj Displaying on Screen information: Press to display all on-screen
indications. Press again to cancel.
Besides TV functions, all coloured buttons as well as green
symbols are also used for Teletext operation. For more details,
please refer to “Teletext” section of this instruction manual.
1
2
3
4
5
6
7
8
9
q;
qa
qs
qd
qf
qg
qh
qj
32CS71 K GB.fm Page 5 Wednesday, February 16, 2005 2:16 PM