Targus DEFCON 3 - Manual (Page 8)

7
PROGRAMMING DEFCON 3 FEATURES
The DEFCON 3 has a Program Mode that enables you to tailor the alarm
unit to your personal preferences through several advanced features.
Accessing Program Mode
1. Make sure the alarm unit is not armed.
2. Press and hold the Program button on the remote control
for three seconds, or until you hear four beeps and the right
LED light glows red: First then .
You are now in Program Mode. If the alarm does not receive a
signal from the remote control for 20 seconds, it will
automatically exit Program Mode. When this occurs, the alarm
unit sounds four short beeps and the LED light goes out.
Navigating Program Mode
Once in Program Mode, you can begin to cycle through the programmable
features.
1. Make sure the alarm unit is not armed.
2. Press and hold the Program button on the remote
control to cycle through the feature’s options in the
following order:
✤ motion sensitivity
✤ alarm volume
✤ alarm siren sound
When cycling through the feature’s options, the first choice is either the
factory default, or the selection presently in use by the DEFCON 3
Security System. The last selection you make for each feature is the one
that will be stored in the alarm unit’s memory.
3. Press and hold the Arm/Disarm button on the remote
control to make your selection.
If you accidentally bypass a feature, continue pressing the Program button
to cycle back to it. For example, if you want to change the alarm volume
but you are in the alarm siren feature, press the Program button once to
advance to the motion sensitivity feature. Press it again to advance to the
alarm volume feature.