Toastmaster 1118 - Manual (Page 5)

4.
Chopster ™ Food Chopper Use and Care Guide
CAUTION: Blades are sharp, handle with care. Do not immerse
motor base in water or other liquids.
3. Place bowl without lid and blades on base. Line up Bowl Tabs with
notches in base and turn clockwise to lock into position.
4. Lower blade over Drive Shaft in bowl, rotating if necessary to
drop into place.
5. Cut food into 1 ⁄
2
inch uniform pieces and place up to 1 1 ⁄
2
cups into
bowl.
6. Place lid on the bowl. Slide Lid Locking Tab into Lid Locking Slot
and turn until the raised arrows are aligned and the lid clicks into
place.
NOTE: The Chopster ™ will not operate unless the lid locking tab
is correctly inserted into the lid locking slot.
7. Plug into a 120V ~ 60Hz outlet.
8. To start, press the PULSE/ON button for 3-5 seconds and then
release; the motor will stop. Repeat pulse for a finer consistency.
If Chopster
™ does not start, repeat steps 3-5 above.
9. When finished chopping, unplug the unit and allow blades to
stop rotating before disassembling.
10. Turn the lid counterclockwise and remove. Carefully grasp stem
of blade and lift out of bowl. Turn bowl counterclockwise to
release and lift off base.
11. Remove chopped food from bowl.
Helpful Hints
◆ Be careful not to over-process. Most foods require only 3-10 seconds.
◆ Process up to 1
1 ⁄
2
cups of food at a time. If larger quantities are
desired, process in several small batches.
◆ If food is not chopping into even-sized pieces, remove some of it
from the bowl and process smaller quantities at a time.
1118/CAN&IB_IB_26-11-04 11/26/04 7:18 PM Page 4